Upgrade from the bootware menu, Bootware menu – H3C Technologies H3C S10500 Series Switches User Manual
Page 14
13
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 2
slot 1!
# Reboot the IRF fabric to validate the upgrade.
Start to check configuration with next startup configuration file, please wait.
........DONE!
This command will reboot the device. Continue? [Y/N]:y
Reboot device by command.
CAUTION:
•
To prevent configuration loss, save the latest configuration changes before you reboot the switch.
•
For more information about the boot-loader command, see the
Fundamentals Command Reference in
the
H3C S10500 Switch Series Command References.
3.
Install the patch package
# Install the patch package S10500R1120Patch001.bin, and configure the device to continue the
installation after reboot.
[Sysname] patch install file S10500R1120Patch001.bin
Patches will be installed. Continue? [Y/N]:y
Do you want to run patches after reboot? [Y/N]:y
Installing patches…
NOTE:
If a patch package was installed before, you must uninstall it before you can install the new one. To view
patch information, use the display patch information command. For details about patch installation, see
the
Fundamentals Configuration Guide in the H3C S10500 Switch Series Configuration Guides.
Upgrade from the BootWare menu
CAUTION:
You cannot simultaneously upgrade the active and standby MPUs from the BootWare menu. To make sure
the active and standby MPUs use the same software version, upgrade them in turn.
BootWare menu
Connect a configuration terminal such as a PC to the console port of the switch with a console cable, run
the terminal emulation program on the PC, and power on the switch.
Upon power-on, the switch runs the BootWare program and displays the following information:
System is starting...
Booting Normal Extend BootWare.
The Extend BootWare is self-decompressing...................................