H3C Technologies H3C S10500 Series Switches User Manual
Page 19
18
NOTE:
•
If no parameters are set, pressing Enter adopts the default settings.
•
You only need to configure settings under
======================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |
| Ctrl+D = Quit. |
============================================================================
Protocol (FTP or TFTP):ftp
Load File Name :test.bin
:main.bin
Target File Name :test.bin
:main.bin
Server IP Address :192.168.80.20
Local IP Address :192.168.80.10
Gateway IP Address :0.0.0.0
FTP User Name :UserN
FTP User Password :PWD
======================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |
| Ctrl+D = Quit. |
============================================================================
Protocol (FTP or TFTP):ftp
Load File Name :test.bin
:main.bin
Target File Name :test.bin
:main.bin
Server IP Address :192.168.80.20
Local IP Address :192.168.80.10
Gateway IP Address :0.0.0.0
FTP User Name :UserN
FTP User Password :PWD
Table 3 Output description
Field Description
Load File Name
Name of the file to be downloaded
Target File Name
Name of the file downloaded to the switch, which must have the same suffix
as the file to be downloaded
Gateway IP Address
Needed when the client and server reside on different subnets
Step5
After you set FTP parameters, the system returns to the Ethernet submenu.
==========================
|Note:the operating device is flash |