Using xmodem through the console port – H3C Technologies H3C S10500 Series Switches User Manual
Page 20
19
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Update Backup Application File |
|<4> Update Secure Application File |
|<5> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
|
============================================================================
Enter your choice(0-5):
Step6
Type a number from 2 to 4 as needed. For example, type 2 to update the main system software image.
The following information appears.
Loading.....................................................................
............................................................................
.........................Done!
31911744 bytes downloaded!
Updating File flash:/main.bin...............................................
....................................................Done!
==========================
|Note:the operating device is flash |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Update Backup Application File |
|<4> Update Secure Application File |
|<5> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
|
============================================================================
Enter your choice(0-5):
Step7
Type 0 to return to the BooWare menu, and type 1 in the BootWare menu to boot the switch.
Using Xmodem through the console port
Step1
Connect the console port of the switch to the PC that stores the .bin file.
Step2
Run the terminal emulation program on the PC. Start the switch, enter the boot menu (see
for more information), and type 2 when you see " Enter your choice(0-9):" to enter the serial
submenu.
===========================
|Note:the operating device is flash |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Update Backup Application File |
|<4> Update Secure Application File |
|<5> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-5):
Step3
Type 5. The baud rate set menu appears.