Using xmodem through the console port – H3C Technologies H3C S10500 Series Switches User Manual
Page 30
29
Field Description
Gateway IP Address
Needed when the client and server reside on different subnets
Step6
After you set FTP parameters, the system returns to the Ethernet submenu.
===================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
Step7
Type a number from 1 to 3 as needed. For example, type 1 to upgrade the entire BootWare. The
following information appears.
Loading...........Done!
447612 bytes downloaded!
Updating Basic BootWare? [Y/N]
Step8
Type Y to upgrade basic BootWare. After the upgrade is complete, the following information appears.
Updating Basic BootWare.........Done!
Updating Extend BootWare? [Y/N]
Step9
Type Y to upgrade extended BootWare. After the upgrade is complete, the following information
Updating Extend BootWare.........Done!
===================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
Step10
Type 0 to return to the BootWare operation menu, and type 0 in the BootWare operation menu to return
to the BootWare menu.
Step11
Type 0 in the BootWare menu to reboot the switch.
Using Xmodem through the console port
Step1
Connect the console port of the switch to the PC that stores the target BootWare image (a .btw file).
Step2
Run the terminal emulation program on the PC. Start the switch to enter the boot menu (see
for more information), and type 7 when you see "Enter your choice(0-9):" to enter the BootWare
operation menu.
=========================
|Note:the operating device is flash |
|<1> Backup Full BootWare |
|<2> Restore Full BootWare |
|<3> Update BootWare By Serial |