Epson EISA Desktop - Manual (Page 140)

Password Problems
If you set a password using the System Configuration program
and you have trouble using your password, check the section
below that describes the problem you are having.
You enter the password, but nothing happens.
Type the password again and press [Enter. You have three
chances to enter it correctly before the system locks up. If this
happens, press RESET to reboot the computer and try again.
If you turned on network server mode when you set your
password, type your password and press twice to see if
your system responds. If not, enter the password again or press
RESET and start over.
You want to change or delete the password.
See Chapter 3 for instructions on changing or deleting your
password.
You have forgotten the current password.
If you have forgotten the current password and cannot use
your computer, follow these steps:
1. Turn off the computer, remove the cover, and disable the
password function by setting jumper Jl on the main system
board to position A. See Chapter 4 for instructions on
accessing the main system board and page 5-2 for the
location of the jumper.
If any option cards are blocking access to the jumper, follow the
instructions in Chapter 5 to remove them.
Troubleshooting C-9