Epson EISA Desktop - Manual (Page 106)

Note
If you remove one IDE hard disk drive and leave another
one in the computer, you must set the jumpers on the
remaining drive to indicate that you now have only one
drive installed. Remove the remaining drive by
following steps 1 and 2 above; then see page 6-3 for
instructions on setting the jumpers.
3. If you are removing your only IDE hard disk drive, you have
already disconnected the cable from the main system board
connector. Store the cable in a safe place in case you install
a hard disk drive later.
4. If you need to connect the drive cable on your remaining
drive, see “Connecting the Cables” below.
Installing a Drive
Follow these steps to install a new drive (or reinstall a drive
you removed):
1. Position the drive so its mounting screw holes face the
outside of the drive bay and its power supply and drive
connectors face the front of the subassembly, as shown in
the following illustration. Then lower the drive into the
drive bay.
6-16 lnstalling and Removing Drives