Epson EISA Desktop - Manual (Page 101)

12. Locate the hard disk drive cable. If you are installing your
first hard disk drive, this cable came in the box with your
computer. If you are installing a second drive, the cable is
attached to your internal hard disk drive.
Align the available cable connector with the drive socket so the
row in the connector with the blocked hole lines up with
the row in the socket with the missing pin, as shown below.
Then push in the connector.
Note
If you are installing your first IDE hard disk drive, you
must also connect the hard disk drive cable connector to
the appropriate connector on the main system board.
First follow the instructions in Chapter 4 to remove the
subassembly. Then connect the cable to the main system
board connector. (This connector, labelled IDE, is located
next to the diskette drive connector.) Next, follow the
steps in Chapter 4 to replace the subassembly.
13. Replace the computer’s front panel and cover as described in
Chapter 4; then follow the “Post-installation Setup
Procedures” on page 4-12 to update your configuration.
Installing and Removing Drives
6-11