beautypg.com

Epson EISA Desktop User Manual

Page 103

background image

3.

4.

5.

Grasp the drive from the front and pull it out.

Note

If you are removing an IDE hard disk drive from the

external bay and it is your only hard disk drive, you

must also remove the hard disk drive cable from its

connector on the main system board. First follow the

instructions in Chapter 4 to remove the subassembly.

After disconnecting the cable from the main system

board connector, replace the subassembly in the

computer as described in Chapter 4.

I

If the drive you removed was accessible from the front of the

computer, you need to reinstall the front panel slot cover

for that drive.

Turn the front panel so you are looking at the inside. Then

press the slot cover into the slot until it is seated in the tabs

on both sides.

Replace the computer’s front panel and cover as described in

Chapter 4; then follow the “Post-installation Setup

Procedures” on page 4-12 to update your configuration.

Installing and Removing Drives

6-13