Amer Networks WS6028 Web GUI - Manual (Page 54)

Basic Management Configuration Chapter 12 Config Push
12-1
Chapter 12 Config Push
Click “WLAN configuration->advanced config->config push” to enter into the config
push page which includes two modules: config push and config push option. The other
AC’s in the cluster will be listed here. You can select which AC to push the configuration to,
and set the different options for each.
12.1 Config Push
The module of config push shows the IP address of an AC in the cluster. One AC can
be chosen to run the “config push”; or all the ACs in the current cluster can run the “all
push”.
The IP addr in the figure means the peer switch; the configuration can be pushed to
these two switches.
If there is no other switch in the cluster, the “IP addr” bar is empty. This function will
only work with more than 1 AC.
12.2 Config Push Option
Used to configure the configuration transferred by the config push option. Every
option is hidden by default. Click “config push option” to open it and click “hide push
option” to auto hide the options.
After selecting the “config push option”, click each option button and select “enable”
or “disable”.