Amer Networks WS6028 Web GUI - Manual (Page 25)

Basic Management Configuration Chapter 5 Networks
5-2
5.2.2 Authentication Mode of Static WEP
Static WEP means that the authentication mode is security mode static-wep. When
connect to the network, the wep key is needed for association. The WEP authentication
mode includes open system and shared key. The WEP key type includes ASCII and HEX.
The length includes 64 and 128.
Example: Configure the authentication as open system, the WEP key type is ASCII,
the length is 64 and the WEP key is 12345 as below:
5.2.3 WEP 802.1x
The WEP 802.1x corresponds to the command of “security mode wep-dot1x”. This
authentication mode needs the WEP authentication of a radius server. The radius server
configuration is viewed in the radius authentication server configuration in “security”. The
WEP 802.1x can also configure the radius accounting server and the configuration is
viewed in the radius accounting server configuration in “security”.
Example: Configure the radius authentication server as the configured wlan1 and
configure the radius accounting server as the configured wlan2. The accounting update
interval, bcast key refresh rate and the session key refresh rate adopt the default WEP
80.21x authentication as below: