Amer Networks SS2GD8I - Manual (Page 70)

64
logout
Syntax: logout
Description: When you enter this command, you will be logged out of the system and disconnected. If
you are connected the switch through the serial port, you will be logged out of the system and be brought
back to the initial login prompt.
Arguments: None.
Example:
SS2GD8I# logout
restore default
Syntax: restore default
Description: When you enter this command, you will receive a prompt saying “Do you want to restore the
default IP address? (y/n)”. If you choose Y or y, the IP address will be restored to the default
“192.168.1.1”. If you choose N or n, the IP address will not be changed.
If the unit was successfully restored to defaults, you will see a prompt asking if you want to reboot
immediately or not. If you press Y or y, the system will reboot immediately; otherwise, you will be taken
back to the CLI prompt. After restoring to defaults, all of the changes in the system will be erased, and the
unit will be reset to factory defaults after being rebooted.
Arguments: None.
Example:
SS2GD8I# restore default
Restoring ...
Restore Default Configuration Successfully
Press any key to reboot system.
restore user
Syntax: restore user
Description: Restores the startup configuration with the saved user configuration. After restoring the
user-defined configuration, all the changes in the startup configuration will be lost. After rebooting, the
startup configuration will be replace with the user defined one. This function requires that a user
configuration be saved first using the “save user” command.
Arguments: None.
Example:
SS2GD8I# restore user
Restoring ...
Restore User Configuration Successfully
Press any key to reboot system.