AEC VacTrac Series Conveying Systems User Manual
Page 68
VacTrac™ Conveying Systems
12-Station Controllers
Page 67
BLINK DELAY: .500s
PRESS ENTER TO SAVE
HI VAC SENSOR DELAY?
NO/YES
LCD Blink Delay lets you alter the
ON/OFF
time that the LCD
blinks during an alarm. This delay does not effect the Visual or
Audible alarm outputs. The delay defaults to 0.5 seconds and
should not be altered unless you are instructed to do so by the
AEC Service Department.
Using the keypad:
Enter the new time and press the
ENTER
key to save the new
settings.
Setting the Hi Vacuum Sensor Delay
At the above message prompt:
Press the
YES
key to enter the Hi Vacuum Sensor Delay Time
menu.
Hi vac sensor delay is the time that a high vacuum condition
must exist before it is sensed by the controller. This delay
eliminates the annoying Hi Vacuum errors which self-clear or
are erroneous. This delay defaults to 3.0 seconds and should
not be altered unless you are instructed to do so by the AEC
Service Department.