AEC VacTrac Series Conveying Systems - Manual (Page 55)

Page 54 12-Station Controllers VacTrac™ Conveying Systems
SET ACTIVE PUMP
SELECT PUMP 1 OR 2
BLOWBACK SETTINGS?
NO/YES
• If you select Single Pump mode, you need to select the active
pump. The following screen prompts you to enter 1 or 2 for
the corresponding pump.
• Selecting the Dual Pump option immediately returns you to
the Pump Settings menu.
!
CAUTION
If you select Dual Pump mode, you MUST assign each station
to a pump. Each station defaults to Pump 1 if not assigned.
Not assigning a station to its related pump
can cause damage to the loading system!
Changing Blowback Settings, Pump Settings Menu
90
As an option, you can equip the conveying system filter chamber
with a blowback feature to pulsate compressed air through the
filter. This function cleans the filter after a pre-set number of load
sequences.
To set up the controller blowback feature, enter the Pump Settings
menu, then:
„ Press the MENU key until the Blowback Settings prompt
screen displays: