AEC VacTrac Series Conveying Systems - Manual (Page 23)

Page 22 12-Station Controllers VacTrac™ Conveying Systems
STATION:-- OFFLINE
TIME: --- Whitlock
P1:S--:--- OFFLINE
P2:S—-:--- OFFLINE
Pump Modes
Single Pump Mode
In Single Pump mode, the screen displays as shown below. The
upper left corner displays the active station being loaded. If the
system has no active station, two (2) hyphens
-- in the station
area display. The lower left corner displays the load time in
seconds. When a station is loading, this area displays how much
time elapses during the load cycle. If no station is active, three (3)
hyphens
--- display.
The upper right area displays the status of the control. This section
displays the condition of the controller, and what action is
occurring in the loading sequence. The different status displays are
described on Pages 24 and 25.
The lower right section of the display is not used in Single Pump
mode. It simply displays the
Whitlock logo.
Dual Pump Mode
In Dual Pump mode, the screen displays as shown on the following
page. The first line of the screen displays information for Pump 1
and the second line of the screen displays information for Pump 2.
Each line has twenty (20) characters divided into two (2) groups of
ten (10). From the left character position,
P0 S:--:--- is read
as “Pump 0 Station --:Load Time ---.” This screen displays
important information in an easy-to-read display. The right ten (10)
character group displays the status of the specific pump. Again, the
different status displays are described on Pages 24 and 25.