AEC WD 350 through WD3000 Dehumidifying Dryers User Manual
Wdmr and wdfr series dehumidifying dryers, Operation and installation manual, Important! read
$30.
00
Operation and Installation Manual
WDMR and WDFR Series
Dehumidifying Dryers
Important! Read
Carefully
Before
Attempting
to
Install
or
Operate
Equipment
Part No. A0547682
Bulletin No. WH1-615
Process Dew Point
10
DEW POINT (F)
35
40
-
-
30
-
25
-
-20
-
-
15
OFF
Temperature
Process Delivery
Temperature
Process Delivery
ON
5
0
-
High Dew Point
In Regen
Left Bed
In Regen
Right Bed
WD Series
Dehumidifying Dryer
Heater on
Left Bed
Heater
Process
Air Temp
Righp Bed
Heater
HI-Process
888
Process Dew Point
10
DEW POINT (F)
35
40
-
-
30
-
25
-
- 20
-
-
15
OFF
Temperature
Process Delivery
Temperature
Process Delivery
ON
5
0
-
High Dew Point
In Regen
Left Bed
In Regen
Right Bed
WD
Series
Dehumidifying Dryer
Heater on
Left Bed
Heater
Process
Air Temp
Righp Bed
Heater
HI-Process
888
Table of contents
Document Outline
- WDMRFRO1.pdf
- WDMRFRO2.pdf
- Down Key
- Up Key
- Optional
- Process Heater On
- Hi-Process Air Temp
- Left Bed Heater
- Right Bed Heater
- Left Bed In Regen
- Right Bed In Regen
- Blower On
- High Regen Air Temp.
- High Dew Point
- Dirty Filter
- POWER ON
- SYSTEM START
- TEMP. SET POINT NORMAL
- ALARM SILENCE
- Process Air Dew Point
- —— PV ——
- Process Value Numeric LED
- —— SV ——
- Set Value Numeric LED
- High Temperature Alarm Indicator
- ALM2 Indicator
- Output Indicator
- Stop Indicator
- HB Indicator
- Input LED Indicators
- Output LED Indicators
- Status LED Indicators
- Level 1 Controllers
- Level 2 Controllers
- Level 1 Controllers
- Level 2 Controllers
- Level 1 Controllers
- Level 2 Controllers
- Recommendations for Cleaning and Replacing Filters
- Level 1 Controllers
- Level 2 Controllers
- Operation when Sensor Fails
- Level 0
- Level 1
- Output Value Screen
- Control Period
- Set Point 0 ((C/(F )
- Set Point 1
- Proportional Band
- Integral Time
- Derivative Time
- Manual Reset Value (%)
- Setting the Current Day of the Week, Hour and Minute
- Setting the Startup Time
- Setting the Stop Time
- Setting the Days of the Week for Automatic Operation
- Placing the Timer in Run Mode
- Water-Cooled Aftercoolers
- Air-Cooled Aftercoolers
- Determining Temperature Controller Errors or Sensor Errors