Welltech ePBX80 V.1.1 - Manual (Page 70)

Welltech Technology Co., Ltd. 70
3.2.9 Dial Group
Dial Group is used to set up the [group dialing]. To enter Group Number and set specific
members is to join this group. To change your Dial Group, click Configuration, and then
click the Dial Group table. The screen appears as follows.
Figure 3.2.9-2 Dial Group Setting
The following table describes the table in this screen
Table 3.2.9-1 Dial Group Setting
Label Description
Group Number Enter the Group Number. The Group number should NOT be the
same with Extension, Trunk Number, and Speed Dial Number.
All of the Numbers should be unique at ePBX80 system.
Telephone Number Enter the Telephone Number to join this Dial Group. You can
enter multiple numbers by a “comma”, such as [101,102,103]
Ring Type You can choose the Ring type for Dial Group; Ring All (Ring all
numbers at this group), Sequential Ring (Ring first one until
Pre-Configured maximum Ring time. If no answer this call, it
ring to next extension) and Random Ring. Extension maximum
Ring time was configured at Section 3.2.1 IP PBX  PBX
Setting  Ext Ring Time.
Dial Group End To This feature decides the final destination if there is not anyone
of group answered this call. You can select IVR or a Number
(extension or PSTN number or SIP Trunk number).
Apply Click the Apply button to save your customized settings and
exit this screen.
Cancel Click the Cancel button to exit this screen without saving.