Welltech ePBX80 V.1.1 - Manual (Page 49)

Welltech Technology Co., Ltd. 49
ringing phone to be answered from another extension.
Note:
Pickup Group is used to control if one extension can answer a
neighbor ring. Both extensions have to configure to the same
call group and pickup group to implement Pickup ring. By
default, dial code *1 can answer any ringing extensions in the
same call group and pickup group.
You can define multiple Call Groups and Pickup Groups to one
Extension by a “comma”. For example, enter “1,3,5” into Call
Group or Pickup Group.
For example:
There are three extensions A, B and C are configured to the
following group table.
Extension A B C
Call Group 1 2 1,2
Pickup Group 1 2 1,2
Case 1.
When A call to B or B call to A, then C can pick up A or B by
dialing service code *1.
Case 2.
When C call to A or C call to B, then A or B can’t pick up the call
by service code *1. Because “A“ can only pick up the “call group
1” and “B“ can only pick up the “call group 2”. Both A and B stay
at two different pick up group. Extension C was assigned to
both Group 1 and 2, so it can be picked up by A and B.
Dial Plan Define the dial plan to Extension. It specifies the instruction
used to control what the phone is allowed to do, and what to do
with incoming calls of this extension. In this field, you can
Choose 5 dial levels for Extension, including
[ext-only],
[ext+R1], [ext+R12], [ext+R123], [ext+allroutes] . You can
define an “Outgoing call” record to certain Route Level.
[ext-only] means this subscriber can only call to Extension.
[ext+R1] means the subscriber with such Dial Plan can call to
Extension and Route Level with R1. [ext+R12] means the
subscriber with such Dial Plan can call to Extension and Route
Level with R1 and R2. [ext+R123] means the subscriber with
such Dial Plan can call to Extension and Route Level with R1, R2
and R3. [ext+allroutes] means the subscriber with such Dial