Welltech ePBX80 V.1.1 - Manual (Page 13)

Welltech Technology Co., Ltd. 13
2.1.1 Network Configuration
To change your Network Setting, click Network, and then click the Network Setting
table. The screen appears as follows.
Figure 2.1.1 Network Setting
The following table describes the features in this screen.
Table 2.1.1 Network Setting
Label Description
WAN Port Setting:
Mode
Select ePBX80 WAN port network mode to be Fixed IP, DHCP
or PPPoE.
Note: If you want other extensions IP devices from Internet to
register to ePBX80 via WAN port, you have to select Fixed IP
mode and give a static and physical IP address.
IP Address Enter the IP Address, If ePBX80 was set to fixed IP mode.
Subnet Mask Enter the Subnet Mask Address, If ePBX80 was set to fixed IP
mode.
Default Gateway Enter the Default Gateway Address, If ePBX80 was set to fixed
IP mode.
Primary DNS Enter the IP address for Primary DNS. The default is
168.95.1.1.
Secondary DNS Enter the IP address for Secondary DNS. The default is null.
Default Gateway
Backup
Select Enable option, if there are any connection problem
occurred on primary default gateway connections, all the traffic