Welltech ePBX80 V.1.1 - Manual (Page 33)

Welltech Technology Co., Ltd. 33
Step 6: If you have exported disconnect tone file to your computer successfully, make sure
to clear PSTN Line number at Disconnect Tone Recording Procedures  General
Setting  PSTN Line No and configure your desire voice codec such as G.729 at
Configuration  IP PBX to set up voice codec priority at G.711U when ePBX80 go back
to normal operation mode. Click Apply and Soft Reset to take effect of your setting. See
the following webpage.
Step 7
: Use third party program to analyze recorded disconnect tone. The procedures
were described at another chapter at this user guide.
Table 3.1.3-1 Disconnect tone Recording Commands
Label Description
Export Export recorded disconnect tone file to your computer. It is a
ZIP compressed file. Please unzip it for analysis.
PSTN Line No Enter a busy Phone number which was connected at PSTN
network.
Line ID for analysis To select a FXO Line ID (FXO Line port from 1 to 8) to use.
Apply Click the Apply button to save your settings and exit this
screen.
Cancel Click the Cancel button to give up change.