Welltech ePBX80 V.1.1 - Manual (Page 22)

Welltech Technology Co., Ltd. 22
Example 1: Set up SIP Trunk number to external FXO gateway and IP Trunk.
This example is to configure Trunk Number to external FXO gateway and IP Trunk. See the
following screen at Figure 2.1.3-2.
Figure 2.1.3-2 Trunk Setting
The following table describes the features at above screen.
Table 2.1.3-2 Trunk Setting
Label Description
Trunk Number
Assign one number to Trunk. This number is also the
registration name for this Trunk device (On-Net or Off-Net FXO
devices).
Note: The Trunk Number can also be a “Trunk ID”. In the
Routing Table page, you should define the destination of prefix
route. When you define the prefix route, you should set the
Trunk ID (Trunk Number) in the Trunk page first; then you
could enter correct Trunk ID in the Destination field.
Password Assign registration password of Trunk device to register at
ePBX80.
Host Setting the Host field to Dynamic enable one trunk device to
register to ePBX80. Then ePBX80 knows how to reach that
trunk device. When the Host field was set to
[Pre-define] , an
IP address or FQDN (domain name) field pop up and need to
define properly.
ePBX80 only recognizes external SIP trunk
with this Pre-define IP address to connect with.
Dial Plan Define the dialing plan for SIP Trunk. It specifies the location of
the instruction used to control which phone number is allowed
to go, and what to do with incoming calls for this Trunk. In this
field, you can Choose 6 dial levels for Extension, including
[from-pstn], [ext-only], [ext+R1], [ext+R12], [ext+R123],