Welltech ePBX80 V.1.1 - Manual (Page 14)

Welltech Technology Co., Ltd. 14
will be guided and switched to the secondary default gateway
for proper operation.
The default is Disable.
Secondary Default
Gateway
Enter the Secondary Default Gateway. If you choose the
Default Gateway Backup to Enable.
Check Point
Enter the Check Point IP address if you choose the Default
Gateway Backup to Enable. ePBX80 uses the ping command to
PING this IP address in order to check if there are any
connection problem occurred on primary default gateway
connections.
Current used Default
Gateway
This field display existing used Default Gateway IP address.
PPPoE ID
Enter the PPPoE ID if you choose the Mode to PPPoE.
PPPoE PWD
Enter the PPPoE Password if you choose the Mode to PPPoE.
MAC
This field shows the MAC address. The MAC address cannot be
modified.
LAN Port Setting:
IP Address
Enter the IP Address. The default is 192.168.123.123.
Subnet Mask
Enter the Subnet Mask Address. The default is 255.255.255.0.
MAC This field shows the MAC address. The MAC address can’t be
changed.
Network Routing Table:
Select
Select this check box, then modify or delete it.
Destination
This field shows the IP address.
Network
This field shows the Subnet Mask address.
Gateway
This field shows the Default Gateway address.
When you enable this feature, ePBX80 sends all packets to this
gateway instead of WAN or LAN gateway. Default is blank.
Add
Click on the Add button, then display Network Routing screen.
Modify IP address can be modified by clicking on the check box next to
the IP address and click on the Modify button.
Delete
IP address can be deleted by clicking on the check box next to
the IP address and click on the Delete button.
Apply
Click on the Apply button to save your customized settings and
exit this screen.
Cancel
Click on the Cancel button to give up these changes.