Welltech ePBX80 V.1.1 - Manual (Page 44)

Welltech Technology Co., Ltd. 44
The following table describes these features in this screen.
Table 3.2.3-1 Feature Code
Label Description
DND Activated The code is to activate DND ( Do Not Disturb ). Default is *78.
DND Deactivated The code is to deactivate DND. Default is *79.
UCF Activated The code is to activate Unconditional Forward . Default is *72.
For example, dialing *72101 will forward all incoming call from
your phone to extension 101.
UCF Deactivated The code is to deactivate Unconditional Forward. Default is *73.
BF Activated The code is to activate Busy Forward . Default is *90. For
example, dialing *90101 will forward call to extension 101 if
you are on the phone.
BF Deactivated This code is to deactivate Busy Forward. Default is *91.
NAF Activated This code is to activate No Answer Forward . Default is *92. For
example, dialing *92101 will forward call to extension 101 if
you are not answering.
NAF Deactivated This code is to deactivate No Answer Forward. Default is *93.
UAF Activated This code is to activate Unavailable Forward. Default is *94. For
example, dialing *94101 will forward call to extension 101 if
your phone is not registering to ePBX80.
UAF Deactivated This code is to deactivate Unavailable Forward. Default is *95.
OUCF Start When you are not able to access Internet to configure your IP
devices, making a PSTN call to ePBX80 via FXO Port or FXO
Gateway to enable remote control function to setup remote
control Unconditional Forward to specific extension.
Default access code is *87+extension number to forward.
Note:
1. You can dial to ePBX80 via PSTN FXO port or FXO gateway,
and it answers call by playing greeting message to ask you to
enter service code.
2. Dial code [*87]+Extension number to enable access this
extension, the greeting messages popup again to ask for dial
access code. For example: dial *87305 will enable extension
305 to accept remote control forwarding feature
. Go to next
command at OUCF Activated to see details.
3. You can enable or disable OUCF function.
OUCF Activated This code is to activate Remote Unconditional Forward number .
Default is *88+forwarding number.