Welltech ePBX80 V.1.1 - Manual (Page 52)

Welltech Technology Co., Ltd. 52
Password Select Normal option to Subscriber Type. Assign the register
password for device to register on ePBX80, the password will
automatically increase by 1 digit.
Call Group You can use the Call Group parameter to assign an Extension to
one or more groups.
It means the SIP extension can be picked
up by other group.
Pickup Group Use Pickup Group option in conjunction with this group to allow
a ringing phone to be answered from another extension.
Note:
Pickup Group is used to control if one extension can answer a
neighbor ring. Both extensions have to configure to the same
call group and pickup group to implement Pickup ring call. By
default, dial code *1 can answer any ringing extensions in the
same call group and pickup group.
You can define multiple Call Groups and Pickup Groups to one
Extension by a “comma”. For example, enter “1,3,5” into Call
Group or Pickup Group.
For example:
There are three extensions A, B and C are configured to the
following group table.
Extension A B C
Call Group 1 2 1,2
Pickup Group 1 2 1,2
Case 1.
When A call to B or B call to A, then C can pick up A or B by
dialing service code *1.
Case 2.
When C call to A or C call to B, then A or B can’t pick up the call
by service code *1. Because “A“ can only pick up the “call group
1” and “B“ can only pick up the “call group 2”. Both A and B stay
at two different pick up group. Extension C was assigned to
both Group 1 and 2, so it can be picked up by A and B.
Dial Plan Define the dial plan to Extension. It specifies the instruction
used to control what behavior of the phone is allowed to do,
and what to do with incoming calls of this extension. In this
field, you can Choose 5 dial levels for Extension, including
[ext-only], [ext+R1], [ext+R12], [ext+R123], [ext+allroutes] .
You can define an “Outgoing call” record to certain Route