Welltech FXSO Gateway In SIP V.1.2 - Manual (Page 87)

FXSO SIP Gateway User Manual Document Ver.: 102
Released Dec., 2004
85
tone [num][freqHi ][freqLo ][freqHiLev][freqLoLev]
[Tone1ON][Tone1OFF][Tone2ON ][Tone2OFF ]]
tone -print Display disconnect tone configuration.
[num] Tone index(1~4:Disconnect tone / 5~8:Remote ring back
tone).
Example:
tone -print
tone 1 620 480 8 8 50 50 1023 1023
usr/config$
Parameter Usages:
-print show all tone configuration
[num] tone index. 1~4 is disconnect tone, 5~8 is remote ring back
tone.
For FXO ports Gateway must detect disconnect tone to
determine when to disconnect the call, so user must set
disconnect tone of PBX or PSTN network connected to FXO
ports.
When making a call from FXO ports, there are 2 ways to
detect callee has already picked up the call, one is to detect
reverse signal, the other is to detect the termination of ring
back tone, so user must set ring back tone of PBX or PSTN
network.
(If user doesn’t know about the frequency of disconnect tone
or ring back tone, please refer to [record] command to detect
frequency.)
For each tone may has 1 set or 2 sets (high and low) of
frequencies. If user wants to set 0 in on/off time, please set
“1023” represent “0”. (ex. tone 1 620 480 8 8 50 50 1023
1023)
(tone “index of tone” “frequency of high” “frequency of
low” “level of high” “level of low” “on time of high” “off
time of high” “on time of low” “off time of low” )
4.2.20 [fxopwd]
This command is for FXO ports.