Welltech FXSO Gateway In SIP V.1.2 - Manual (Page 86)

FXSO SIP Gateway User Manual Document Ver.: 102
Released Dec., 2004
84
Ringback Tone frequency high level : 13
Ringback Tone frequency low level : 13
Ringback Tone tone1 on : 100
Ringback Tone tone1 off : 200
Ringback Tone tone2 on : 1023
Ringback Tone tone2 off : 1023
usr/config$
Note:
For tone simulation, Gateway adopts dual frequencies as traditional
telephone does. If users want to have their own call progress tone, they
can change the value of tones. High and Low frequency/level/cadence
can be configured respectively.
-ring to set RING Tone value.
The played tone type, when Gateway is receiving a call.
-rbt to set Ring Back Tone value
The played tone type, when Gateway receives a Q.931 Alerting
message. In condition that Gateway is the originate side.
-bt to set Busy Tone value.
The played tone type, when destination is busy.
-dt to set Dial Tone value.
The played tone type, when off hook a phone set of workable
Gateway.
-2dt to set the 2
nd
dial tone value.
The played tone type, when the unit accept the call hold function,
it will generate the 2
nd
dial tone.
-flash set the detective flash range in ms, for example, 300-500 ms.
4.2.19 [tone]
This command is basically for FXO ports.
-----------------------------------------------------------------------------------------------
usr/config$ tone
Disconnect tone and remote ring back tone configuration
Usage: