Welltech FXSO Gateway In SIP V.1.2 - Manual (Page 70)

FXSO SIP Gateway User Manual Document Ver.: 102
Released Dec., 2004
68
type, “1” means the hardware type is 1FXS+1FXO, “2” means
the hardware type is 2FXS+2FXO.
Note:
The default value is to auto detect hardware type. Usually it is
not necessary to change this setting. Please make sure about
your Hardware Type, Gateway may be not functional if set
wrong hardware type.
-callerid Caller ID function disables or enable. The caller ID will be
disable if user out the value 0 in this configuration or users
could put the value 1 to enable the FSK caller ID function.
Please check out the phone set could support the FSK caller
ID display. (0 for disable ; 1 for FSK type.)
-ring ring time for ring detection(in ms). When Gateway has
incoming call from PSTN side to FXO port, Gateway will
determine it is a ring but not noise only if it is longer than this
ring time.
Note:
In Taiwan the ring time of PSTN usually is 1000ms, so if user
set ring time longer that 1000ms, FXO port may not be able to
pick up the call from PSTN side.
-rba When the calls from the PSTN side, FXO port will off hook if
the ring time is matched with this number.
-eod It will transfer the DTMF in “#” if users disable the end of dial
function. Users have to press the key pad in “#” if the end of
dial function is enable.
-connect The unit will send the connect message to the IP side
automatically. This function just supports the
one-stage-dialing function.
4.2.11 [sip]
This command is for sip configuration related parameters.
-----------------------------------------------------------------------------------------------
usr/config$ sip
sip stack information and configuration
Usage:
-print Display SIP stack information and configuration.
-mode Configure as Proxy mode or Peer-to-Peer mode.