Welltech FXSO Gateway In SIP V.1.2 - Manual (Page 77)

FXSO SIP Gateway User Manual Document Ver.: 102
Released Dec., 2004
75
-add add a routing rule in routing table. User can add less than 50
rules. (route –add prefix “prefix number” dst “destination
port type” e164 “SIP number of port” min “minimum
digits needed” max “maximum digits can’t be
exceeded”)
-delete delete a routing rule in routing table (route – delete “index of
routing rule”)
-modify modify a routing rule in routing table. (route –modify “index
of routing rule” prefix “prefix number” dst “destination
port type” e164 “SIP number of port” min “minimum
digits needed” max “maximum digits can’t be
exceeded”)
-ip create routing table for incoming call from IP side. (route – ip
dst “destination port type” e164 “SIP number of port”)
-fxs create routing table for incoming call from FXS TELs.
(route –fxs dst “destination port type” e164 “SIP number
of port”)
-fxo create routing table for incoming call from FXO Lines.
(route –fxo dst “destination port type” e164 “SIPnumber
of port”)
prefix prefix of dialed number
dst destination port, 0 means FXS TELs, 1 means FXO Lines, 2
means IP side, x means no determinate number.
e164 destination SIP number. This only need to be set when routed
port is FXS TELs or FXO Lines to determine which port will
this call be routed to.
min minimum digits needed.
max maximum digits needed.
hunt set hunt method for busy forward. 0 means no hunting, 1
means hunting method follows the rule of [line], 2 means
hunting method is to hunt between all ports in the same type,
for example, destination port is FXS TEL will hunt in all FXS
TELs, destination port is FXO Lines will hunt in all FXO Lines.
Usage Example:
1. route –add prefix 100 dst 0 e164 1001 min 1 max 3 hunt 1
This command means if gateway has incoming call’s prefix number is