Welltech FXSO Gateway In SIP V.1.2 - Manual (Page 69)

FXSO SIP Gateway User Manual Document Ver.: 102
Released Dec., 2004
67
2FXS+2FXO:2)
-callerid CallerId Type .(Caller type, 0: none, 1: FSK)
-ring The ring time for ring detection.(Uint:ms)
-rba The number of ring times before answer.(1~5)
-eod End of dial.(Enable: 1 / Disable : 0)
-connect Auto connect time.(0=Disable, for 1~65535 sec)
Example: sysconf -ring 500
usr/config$
Parameters Usage:
-print print out all current settings
-idtime set the duration(in second) of two pressed digits in dial mode
as timed out. If after the duration user hasn’t pressed next
number, it will dial out all number pressed. (1-10 seconds)
-forwardtime set forward time(5-65535 seconds)for FXS Line. If called
party hasn’t answered the call in this time, call will be
forward to assigned number in [line] command. (please
refer to [line] command for forward setting)
-keypad DTMF replay type. When value is “0”, Gateway will transfer
DTMF signal via In-Band type, “1” via RFC2833 type. Users
can adjust the value according to various applications.
1. number (instead of Line number of FXO Line)+ PSTN
number to make a call to PSTN side connected with FXO
Line.
2. After gateway-prefix-drop function is enabled, user must
remember to re-configure line number of FXS Line,
because line number of FXS Line must remove prefix
number. For example, origin line number of FXS line is
1001, prefix is 100, since prefix number will be drop, once
gateway has incoming call 1001, after drop gateway prefix
100, it wi ll search line number “1”. So line number must be
set as “1”.
-hwtype application rom file of 37 series are the same no matter how
many ports is the module, so after user downloads the
application rom file, user can select which hardware type
is . ”0” means gateway will automatically detect the hardware