Welltech FXSO Gateway In SIP V.1.2 - Manual (Page 74)

FXSO SIP Gateway User Manual Document Ver.: 102
Released Dec., 2004
72
TEL2 as hunt group 2, they will be determined as 2 different
groups. On the other hand, if user assigns FXS TEL1 as hunt
group 1, and FXS TEL2 as hunt group 1 too, when having
incoming call to FXS TEL1, which is busy, this call will be
route to FXS Line2.
Note: FXO Lines and FXS TELs are treated as 2 different
groups, so even they are in the same hunt group, call will only
be routed to the same FXS or FXO Lines.
-hotline set hotline table. The Hotline Mode is applied in limited two
channels. User just picks up the phone set of one FXS TEL or
calls in one FXO line, and gateway will automatically dial out
a phone number. In the other hand, user will hear ring back
tone or dial tone immediately depended on configurations of
destination device.
Note: This function can both work in Proxy or P2P mode.
(1) Call out from FXS Line
Proxy Mode Usage:
Set gateway under proxy mode.
Create a Hotline table with “line ” command.
-------------------------------------------------------------------------------
usr/config$ line –config 1(3) hotline 1001
-------------------------------------------------------------------------------
In this example means: if user picks up phone set of FXS
Line1, gateway will automatically dial out “1001”.
P2P Mode Usage:
Set gateway under P2P mode.
Create phone book table with “pbook ” command.
Create a Hotline table with “line ” command.
-------------------------------------------------------------------------------
usr/config$ pbook –add name sipfxso ip 10.1.1.1 e164 1001
usr/config$ line –config 1(3) hotline 1001
-------------------------------------------------------------------------------
In this example means: if user picks up phone set of FXS
Line1, gateway will automatically dial out IP address of
“1001”.