Welltech WG2504 FXS V.4.02 - Manual (Page 89)

89
Each option values description
 TeL No: FXO Tel No number
 Polarity Reversal Detection: 0 is disable, 1 is enable.
 Current Drop for Disconnect: 0 is disable , 1 is enable.
 Incoming Call Handling: 0 is Hot line , 1 is 2 stage dialing.
 Hot Line Tel: this port hot line number.
 FAX Relay: 0 is disable, 1 is bypass, 2 is T38
 Flash Time(sec): this fxo port flash time
 Input(Encode) Gain: the range is from 0(mute) to 37(+5db)
 Output(Decode)Gain: the range is from 0(mute) to 37(+5db)
 Dialing Answer Delay Time(sec): unit is sec
 PSTN Answer Ring Count: PSTN Answer Ring Count
 Caller ID Mode: none is -1, Bellcore FSK is 1, ETSI FSK is 2, ETSI
DTMF is 3, Danish DTMF is 4, Indian DTMF is 5, Brazilian DTMF is 6.
 Playback Voice File: 0 is disable, 1 is enable.
 Repeat Count: the repeat count
 Voice File Name: the voice file name (default is greeting.pcm)
 0: it is reserved field, please don’t change this value.
 0: it is reserved field, please don’t change this value.
 0: it is reserved field, please don’t change this value.
 0: it is reserved field, please don’t change this value.
 0: it is reserved field, please don’t change this value.
Example:
1.
Set the fxo tel no to 999 and hotline number to 888.
This command is
“[bdb -i Line -a fxo1 -v
999,0,0,0,888,2,500,32,32,3,2,3,1,5,greeting.pcm,0,0,0,0,0]”
If input command is
“[bdb -i Line -a fxo1 -v 999,0,0,0,888]”
The behind values will be changed to 0
Notice: please input completely command line, there should have 19
commas(,).
2.
Read each line values
This command is “[bdb –i Line –a fxo1]”