Welltech WG2504 FXS V.4.02 - Manual (Page 67)

67
Appendix B --- HTTP auto provisioning
Get the http provisioning packet from Welltech and start the provisioning as
follows:
Step 1: build mac list for mass configuration file generation
Please open the “wg2504 MAC.csv gotten from Welltecg by using Microsoft
Excel. You can refer the picture below. Normally, you should get all required
configuration mac list from Welltech and use it for configuration file
generation.
For FXS>
The wg2504 MAC.csv contains most frequently changed parameters as
following:
MACAddress: Wellgate 2504 MAC Address
fxs1.displayname ~ fxs4.displayname: display name for each line
fxs1.password ~ fxs4.password: user password for register to SIP proxy
for each line
fxs1.telno ~ fxs4.telno: tel no for each line
fxs1.userid ~ fxs4.userid: user id for register to SIP proxy for each line
Please save and close it.
Step 2: create a template configuration file
Open the “wg2504 Parameter.txt” getting from Welltech and make the
required change. Please at least make the changes for those provisioning and
SIP proxy settings.
For detail, please refer the comments of “wg2504
Parameter.txt”.
Step 3: Make the change for wegencfg.ini as follows if necessary
# Template File
BaseFile=.\wg2504 Parameter.txt
# MAC list file
ListFile=.\wg2504 MAC.csv