Welltech WG2504 FXS V.4.02 - Manual (Page 20)

20
2-5 Debug Settings
Wellgate 2504 provides the real time debug to syslog or through telnet interface. It
generates the debug information based on debug level and modules. Since the
generating debug will consume system resource, it is recommended to turn on only for
necessary and under Welltech FAE’s instruction.
Debug
Figure 2-5 Debug setting
Parameter Description:

SYSLOG: Enable or disable to send system information to SYSLOGD
server or not
 Check for start from Any Time: Always Send: Always send syslog or
only during a specified time range.
 Syslog Start (YYYY/MM/DD HH:MM): Always Send: Always send
syslog or only during a specified time range.
 Syslog Stop (YYYY/MM/DD HH:MM): The syslog stop sending time.
 Syslog Server: Syslog server IP address
 Syslog Port: syslog server service port (default is 514)
 DSP Debug: Enable or disable to send DSP information to capture log
 DSP Capture server: Syslog capture server IP address
 DSP Capture port: syslog capture server service port (default is 50000)