Welltech WG2504 FXS V.4.02 - Manual (Page 74)

74
WellGate 2540 (FXO Gateway) configuration
Step 1: set static IP address to WellGate 2540 FXO gateway’s WAN port as
following picture. See Figure 8. For example: Set static IP address
192.168.23.23 on Device Setting Network of WellGate 2540 WEB page.
See Figure 7
Figure 7.
Step 2: Set the FXO SIP line’s information to each line.
Go to FXO Setting webpage of WellGate 2540 FXO Gateway and configure
each line by selecting Line ID from 1 to 4. See Figure 8 and Figure 9. Enable
Hotline feature by selecting Incoming Call Handling to
Hot Line and give
remote WellGate 2504 FXS gateway port 1 number to 501. Enter the numbers
of TEL No
1001 to 1004 from port 1 to port 4 .
For example:
FXO SIP port 1 number 1001 hotline to remote FXS port 1 number 501
directly.
FXO SIP port 2 number 1002 hotline to remote FXS port 2 number 502
directly.
FXO SIP port 3 number 1003 hotline to remote FXS port 3 number 503
directly.
FXO SIP port 4 number 1004 hotline to remote FXS port 4 number 504
directly.