Wavetronix SmartSensor Advance Extended Range (SS-200E) - User Guide - Manual (Page 44)

In this chapter
˽ Serial Connection
˽ Internet Connection
˽ Virtual Connection
˽ Multi-drop Network
˽ Address Book
˽ Viewing Connection Information
˽ Uploading the Sensor’s Embedded Software
4
Once the sensors are installed, use the SSMA software to change settings, view data and
configure the sensors to the roadway.
Launch SSMA by either clicking on the icon that was placed on your desktop or clicking
the icon found in the Start menu. The SSMA main screen shown in Figure 4.1 will appear.
If you are using SSMA on a laptop computer, you can use the panel in the lower left of the
main screen to change the size of the user interface on your computer. Click any of the three
squares to increase or decrease the size of the user interface.
Communication
4