Wavetronix SmartSensor Advance Extended Range (SS-200E) - User Guide - Manual (Page 136)

CHAPTER 12 • PROGRAMMING CONTACT CLOSURES 135
Rotary Switch Front Panel Menu Click Supervisor
Baud Rate No Yes Yes
Channel Input Map Yes Yes Yes
Autobaud No Yes No
Reset to Default No Yes Yes
Description No No Yes
Location No No Yes
Device ID No No Yes
Fail-safe Settings No No Yes
To use this
configuration option:
Hardware mode Software mode Software mode
Table 12.1 – Click 104 Configuration Options
If you have used the rotary switch to set the channel input mapping (which is the only thing
you can do with the rotary switch), that mapping cannot be set or changed with the front
panel menu or Click Supervisor. If the rotary switch is set to 0, you can set channel input
mapping using Click Supervisor or the front panel menu.
Note
If any setting has been set using both the front panel menu and Click Supervisor,
whichever configuration was set most recently will be the one that counts.
See the Click 100-400 Series User Guide for more information on these contact closure de-
vices.