Wavetronix SmartSensor Advance Extended Range (SS-200E) - User Guide - Manual (Page 135)

134 CHAPTER 12 • PROGRAMMING CONTACT CLOSURES
Figure 12.4 – Click 104 Wiring Diagram
Note
If you’re using the Click 223, you only need to follow steps 1 and 2 twice, as those
devices only connect to a single sensor.
Click 104 Configuration
You can configure the Click 104 with Click Supervisor, using the front panel menu or us-
ing the rotary switch. Each configuration option allows you to change different parameters;
some parameters can only be configured using one option, while others can be configured
using any of the three. Table 12.1 below gives you an idea of which parameters can be con-
figured using which configuration options.