Visara Master Console Center Operations Guide - Manual (Page 74)

Visara Master Console Center
74 © Visara International 2007
Configuring a Console’s Characteristics
Roll Mode
To manually set the console’s message correctly rolling for MCC usage, do the following:
Note: Anytime the system is re-IPLd, the rolling will have to be manually
set again. Therefore ensure roll setting is correct in the console gen
itself.
1. Enter K S
2. Change the MODE=x to MODE=R
3. Change the RTIM value for the number of seconds to wait before scrolling
Screen Positioning
To turn off split screen, enter:
K A,NONE (set area to none)
To reset from screen centering, enter:
K E,D
Active Console Information
To view information about the active console, enter:
D C,A
The information is displayed in the order:
Name Address ConsID
Where:
Name is the name of the device (if applicable)
Address is the address of the device on the controller
ConsID is the console id number