Using hp700 consoles, Function keys – Visara Master Console Center Operations Guide User Manual
Page 33
Chapter 3 Selecting Consoles
Operations Guide
33
Using HP700 Consoles
The HP700/92 Unix console emulation provided by the MCC is designed to support applications
such as SAM and NMMGR; other applications that are not run at a console may not function
correctly. The emulator functions only in HP mode – no EM modes are implemented.
Note: The environment variable TERM must be set to hp. Other values of
TERM may be available – check the terminfo/termcap entries.
The following keys have special functions in this emulation. Other keys and combinations have
the same functions as on a standard HP keyboard.
Key or Key Combination
Function
F11
Clears the current line.
F12
Toggles between the modes, user, and
system function key sets. This key is
only available when one of these key sets
is displayed.
Shift+Up Arrow
Scrolls up. The top line is removed.
Shift+Down Arrow
Scrolls down. The bottom line is
removed.
Table 6. HP700/92 Console Emulation, Supported Special Function Keys
The following command sequences are available in this emulation:
Key Sequence
Function
Sense cursor position relative.
Return terminal primary status.
Return terminal secondary status.
Start an unprotected field.
Start a transmit only field.
End a field.
tab.
tab.
Clear all tabs.
tab.
tab.
Set left margin.