Verilink T1 Access Router (34-00327) Product Manual - Manual (Page 68)

3-40 T 1 A c c e s s R o u t e r
Figure 3.31 Rule Details Screen
The paragraphs below describe the rule configuration parameters and their
options.
Service Selects the service to which the rule applies. Select from a pull-down list of
available services.
NOTICE: If you change the Service parameter, you must click on “Submit” to see
the appropriate DLCIs.
DLCI Selects the DLCI to which the rule applies from a pull-down list of applicable
DLCIs.
Filter By DLCI Enables or disables filtering of the IP traffic by the DLCI specified in the
DLCI pull-down list.
NOTICE: To use this filter, you must specify both the Service and DLCI
parameters in the rule configuration.
IP Address Establishes the IP address by which the rule will filter IP traffic (if enabled).
IP Mask Represents a range of IP addresses defined so that only machines with IP
addresses within the range defined by the mask are allowed to access an
Internet service. To mask a portion of the IP address, replace it with the wild
card character “0” (zero). (For example, 192.44.0.0 represents every computer
on the Internet with an IP address beginning with 192.44.)
Filter By IP Address Enables or disables filtering of the IP traffic by the IP address specified in the
IP Address or IP Mask field.
IP Port Establishes the IP port by which the rule will filter IP traffic (if enabled).