Verilink T1 Access Router (34-00327) Product Manual User Manual
Page 120
4-12
T 1 A c c e s s R o u t e r
Figure 4.10
IP Details Screen
IP Address
A unique Network address assigned to this unit.
Subnet Mask
Defines the Network portion of the unit’s IP address.
Gateway IP Address
IP address of the default gateway (router) on the LAN side of the unit.
DHCP Client
If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
NOTICE:
Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
Client Identifier
Displays a unique identifier for a specific IP address.
Physical Address
Displays unique MAC address.
NOTICE:
If you manually change the IP address, you must “Save and Restart.”
(See Save and Restart on page 4-6.)
Select the Unit Access Table prompt on the Ethernet (IP Details) screen to
view the Unit Access Table (Figure 4.11), which specifies up to 10 different
IP networks that may access the unit. If no IP networks are supplied, any host
can access the unit. Select an
Access Details (Figure 4.12) that correspond with that number.