Verilink T1 Access Router (34-00327) Product Manual - Manual (Page 49)

W e b S e r v e r I n t e r f a c e 3-21
frame relay connection. Also if set to “Yes,” the unit will gather SLA
parameters such as frame and data delivery ratio as defined in the Frame
Relay Forum Implementation, FRF.13. Those gathered statistics are then
displayed on the DLCI Statistics screen as shown on page 3-37.
Values: No, Yes
Default: No
Round Trip Delay Size
(bytes)
Specifies the frame size (in bytes) of packets making the round-trip.
Round Trip Delay Rate
(secs)
Specifies the rate (in seconds) at which Round Trip Delay packets are sent.
Status and Alarms Table
The table displayed at the bottom of the Frame Relay Service Details screen
reports on the status and condition of LMI parameters and on Receive/
Transmit alarms and thresholds. Alarm threshold levels may be changed by
entering a new threshold value in the appropriate field of the table and
clicking the “Submit” button. Table fields are described below.
Active Read-only field shows whether or not (Yes or No) an alarm is active.
LMI Type Read-only status indicates ANSI, CCITT, LMI rev. 1, or Unknown.
FrameStart Status Read-only status indicates Sourcing, Monitoring, or 0.
Rx Invalid Threshold Number of invalid frames received during a 15-minute interval after which an
invalid alarm will be triggered. Default of “0” disables this alarm.
Rx Invalid Alarm Status of this alarm indicates OK or Alarmed.
Tx Threshold Number of bits per second sent during a 15-minute interval after which a Tx
alarm will be triggered. Default of 0 disables this alarm.
Tx Alarm Status of this alarm indicates OK or Alarmed.
Rx Threshold Number of bits per second sent during a 15-minute interval after which an Rx
alarm will be triggered. Default of 0 disables this alarm.
Rx Alarm Status of this alarm indicates OK or Alarmed.
The Frame Relay Details screen provides the following user-activated buttons:
Button Function
Submit Sets any values that have been changed.
Frame Relay Statistics Opens the Frame Relay Port Statistics screen for the current
Frame Relay service.