Verilink DPRI 2922 (880-503142-001) Product Manual - Manual (Page 84)

Troubleshooting
4-6
Verilink DPRI 2922
Interpreting Front Panel LEDs
The LED indicators on the front panel of the DPRI 2922 module
display errors caused by network line or data terminal equipment
problems. The errors are reflected in the alarm status and the
performance/status menus in the ASCII terminal interface. Node
Manager also has an alarm display.
There are five LEDs on the front panel:
• Two network port LEDs
• Two data port LEDs
• One system LED
Figure 4-2 DPRI Front Panel Showing Alarm Indicator LEDs
Network LEDs Network LEDs display minor, major, and catastrophic alarm
conditions detected on the network line.
Table 4-2 Network LED Indicators
EXT PRI
MANAGEMENT
SYS
LOCAL
2
NET DATA
1
2 1
DPRI 292
Port LEDs
System LED
State Color Alarm Class Action/Possible Error Condition
Solid Green All okay None
Solid Amber
Diagnostic
mode with no
errors
None
Flashing
Amber and
Red
Yellow Alarm
Check the diagnostic performance status or alarm status
displays. The Yellow Alarm indicates that the unit is
receiving an RAI Signal, which indicates that the far end is
not receiving a signal from the near end.
Solid Red Major
Check the performance status or alarm status display. Loss
of Signal (LOS) from far end transmits all-ones.
Off None None Port is not enabled.