Verilink DPRI 2922 (880-503142-001) Product Manual - Manual (Page 25)

Quick Set-Up
Verilink DPRI 2922 2-9
11. Press SM, then 1, E NTER , to select the TM for Data Port 1. Press
SM, then 2, E NTER , to select the TM for Data Port 2.
NFAS
1. For NFAS mode (If you want the increased bandwidth
capability from grouping the two lines together):
a. Activate NFAS by pressing F1 for Port 1. Select NFAS.
Since NFAS controls the other port as well, there’s no need to
configure both ports. The NFAS configuration will apply to
BOTH ports. (Port 1 is then the “controlling” port.)
b. Reboot the module by exiting all the way to the Main
Menu, selecting O to display the Administration Menu,
Figure 2-8. The card may also be rebooted by unseating it,
then reseating it. (Rebooting is required whenever the
NFAS setting is changed.)
Figure 2-8 NCM Controller Administration Menu (DIDCSU 2912 Card Administration Submenu)
a. Select R) “reset card” to reboot the module and
implement NFAS.
NOTE: If you use ESF/B8ZS:
Do not invert the D Channel
Use 8 bits on the D Channel
If you use SF/AMI:
Invert the D Channel
Use 7 bits on the D Channel
[0.0.0.5] [1,2] DIDCSU 2912 > o
-- NCM CONTROLLER ADMINISTRATION MENU --
Date/Time/Zone: 3-10-97 13:52:59
Node Address: [0.0.0.5]
Node ID: 1
Site Name: TAC-LAB
System Uptime: 4:03:03
--- DIDCSU 2912 -- Card Administration -- [01,02] ---
O) switch over permanent
Q) query firmware
R) reset card
Y) switch over once
U) clear card configuration
X) exit this screen
[0.0.0.5] [1,2] DIDCSU 2912 >