Verilink DPRI 2922 (880-503142-001) Product Manual - Manual (Page 37)

Configuring the DPRI 2922 Via the NCM 2000 Craft Interface
Verilink DPRI 2922
3-7
T1 Port
Configuration
Menu
To access the T1 Port Configuration Menu, enter P from the
Configuration Menu.
To change a port configuration, enter the command followed by the
port number. For example, to remove port 2 from service, In, enter
I2 (n is a variable that identifies the port number).
Figure 3-4 DPRI 2922 T1 Port Configuration Menu
Following is a brief description of the T1 port configuration
parameters:
Table 3-5 T1 Port Configuration Menu Commands
[0.0.0.5] [1,2] DPRI 2922 > p
-- DPRI 2922 T1 PORT CONFIGURATION MENU --
PORT 1 PORT 2
In) In Service YES YES
Fn) Frame Format ESF ESF
Ln) Line Coding B8ZS B8ZS
Bn) Line Build Out 0db 0db
NDn) Network Density NONE NONE
NLn) Network Initiated Loop YES YES
An) Alarm Declare Time(sec) 1 1
DLn) FDL Enable YES YES
PRM Enable YES YES
En) Enable Inband/ISDN Inband ISDN
Sn) Inband Timeslot 1 1
F) FDL configuration
T) Timing
X) Exit this screen
Command Description Options
In In Service: Use this option to place the port in service. Yes or No
(Y/N)
Fn Frame Format: Choose SF (Superframe) or ESF (Extended Superframe
Format) as dictated by what your installation supports. ESF is
recommended. Select SF for installations not supporting ESF.
SF provides traffic signaling and framing. It is sometimes referred to as D4.
Caution: Setting the framing to SF renders other parameters—such as
FDL, below inoperative.
ESF provides cyclic redundancy check, performance monitoring, data
checking, and link bits (Facility Data Link, or FDL).
1) SF
2) ESF