Verilink DPRI 2922 (880-503142-001) Product Manual - Manual (Page 64)

Configuring the DPRI 2922 Via the NCM 2000 Craft Interface
3-34
Verilink DPRI 2922
Figure 3-24 Counter Menu
Table 3-20
Counter Menu Commands
Net Port Alarm Menu
To access the Net Port Alarm Menu, enter A from the Main Menu,
Figure 3-1. Use this menu to set alarm threshold values, monitor
alarm status, and set other alarm parameters. All monitored
conditions are also reflected by LED states.
Figure 3-25 Net Port Alarm Menu
Table 3-21
Net Port Alarm Menu Commands
Command Description
Rn Reset Counters: Returns the values of the BPV, FE, ESF, and CRC counters to zero or N/A.
X Exit this screen—Returns to the Performance/Status Menu, Figure 3-21, Table 3-18.
[0.0.0.5] [1,2] DPRI 2922 > c
-- DPRI 2922 COUNTER MENU --
BPV FE ESF CRC
PORT 1 1 0 65535 0
PORT 2 0 0 65535 0
Rn) Reset counters X) exit this screen
[0.0.0.5] [1,2] DPRI 2922 >
Command Description
N Network Management System (NMS) Address: This option sets the ACP address (which is the
address of the PC that will receive the alarms). Though this address is significant for Node
Manager, it is not important for the ASCII interface.
A Card Alarm Reporting: This option enables or disables the module from sending alarms.
C Configure Thresholds: To disable any or all alarm conditions, enter a threshold value of 0.
To enable a condition, specify any non-zero threshold value. Figure 3-26, Table 3-22.
S Alarm Status: Displays the Net Port Alarm Threshold Status Menu which shows the counts
and intervals of the LOF, LOS, RAI, AIS, BPV, ES, and SES registers. Figure 3-27.
Tn Set Default Thresholds—Resets the module and loads the factory default threshold settings.
X Exit this screen—Returns you to the Main Menu, Figure 3-1.
[0.0.0.5] [1,2] DPRI 2922 > a
-- DPRI 2922 NET PORT ALARM MENU --
N) NMS Address 128.0.0.0
A) Card Alarm Reporting YES
C) Configure Thresholds S) Alarm status
Tn) Set Default Thresholds X) exit this screen
[0.0.0.5] [1,2] DPRI 2922 >