Verilink DPRI 2922 (880-503142-001) Product Manual - Manual (Page 24)

Quick Set-Up
2-8 Verilink DPRI 2922
Figure 2-7 Data Port Configuration Menu
3. In the Data Port Configuration Menu, press the letter I, then
the numeral 1, E NTER , then Y, to place Data Port 1 in service.
Press the I, then 2, E NTER , then Y, to place Data Port 2 in
Service.
4. Press M, then 1, E NTER , to select the Data Port Mode for Data
Port 1. Press M, then 2, E NTER , to select the Data Port Mode for
Data Port 2.
5. Press C, then 1, E NTER , to select the clock option for Data Port
1. Press C, then 2, E NTER , to select the clock option for Data
Port 2.
6. Press O, then 1, E NTER , to select whether or not to Enable LOS
Detection for Data Port 1. Press O, then 2, E NTER , to select
whether or not to Enable LOS Detection for Data Port 2.
7. Press L, then 1, E NTER , to select the Control Line Indicator for
Data Port 1. Press L, then 2, E NTER , to select the Control Line
Indicator for Data Port 2.
8. Press SR, then 1, E NTER , to select the DSR for Data Port 1. Press
SR, then 2, E NTER , to select the DSR for Data Port 2.
9. Press SS, then 1, E NTER , to select the CTS for Data Port 1. Press
SS, then 2, E NTER , to select the CTS for Data Port 2.
10. Press SD, then 1, E NTER , to select the DCD for Data Port 1. Press
SD, then 2, E NTER , to select the DCD for Data Port 2.
-- DIDCSU 2912 DATA PORT CONFIGURATION MENU --
PORT 1 PORT 2
In) In Service YES YES
Mn) Data Port Mode DCE DCE
Cn) Clock Option ST ST
On) Enable LOS detection DTR NO
Ln) Control Line Indicator LOW LOW
SRn) DSR/LOW DSR/LOW
SSn) CTS/LOW CTS/LOW
SDn) DCD/LOW DCD/LOW
SMn) TM /LOW TM /LOW
DTR/LOW DTR/LOW
RTS/LOW RTS/LOW
LLB/LOW LLB/LOW
RLB/LOW RLB/LOW
Cable ABSENT PRESENT
DPL Loopback DISABLE DISABLE
Test Pattern NONE NONE
Test Error Counter 0 0
X) exit this screen
A [127.255.255.0] [1,2] DIDCSU 2912 >