Verilink DPRI 2922 (880-503142-001) Product Manual - Manual (Page 31)

Verilink DPRI 2922
3-1
Chapter
3
Configuring the DPRI 2922 Via the
NCM 2000 Craft Interface
ISDN Access
For ISDN functionality, the DPRI 2922 Craft interface must be
accessed from the NCM 2000 module. This may be done with a
direct cable connection from the NCM 2000 module front panel to
an ASCII terminal or PC running a terminal emulator program, or
using the NCM 2000’s Telnet capability.
To set up the dial-backup circuit feature, please see Chapter 2,
“Creating an ISDN Dial-Backup Circuit”.
ISDN and Routine
Management
Tasks
The following major functions are available through the Craft
interface:
• T1 port, data port, and timing parameter configuration
• Network and data port diagnostics
• Performance, status, and alarm monitoring
• Circuit building, editing, and viewing
In addition to the Craft interface, you can use Verilink’s Node
Manager—a graphical user interface (GUI) management software
package—to configure the DPRI module. For more information, see
the Node Manager for Windows 95 User Manual.
Logging On
1. To access the NCM/DPRI for the first time via the NCM 2000, at
the psH+> psH+> psH+> psH+> prompt type craft (in lowercase letters), then press
E NTER . (Note that the NCM interface will return you to the
psH+> psH+> psH+> psH+> prompt after 15 minutes of inactivity at the keyboard.)
2. When accessing the NCM/DPRI for the first time, at the
YOUR PASSWORD: YOUR PASSWORD: YOUR PASSWORD: YOUR PASSWORD: prompt, press E
NTER .
Until you change the password, the E NTER key is the default
password. If you have changed the default password, then
type the correct password (up to 8 characters, including
spaces). The screen will display placeholders (
****** ****** ****** ******) as you
type the password. After typing the password, press E NTER .