Verilink DPRI 2922 (880-503142-001) Product Manual - Manual (Page 51)

Configuring the DPRI 2922 Via the NCM 2000 Craft Interface
Verilink DPRI 2922
3-21
Table 3-13
Port n PRI Call Profile Configuration Menu Commands
PRI Port n Add Call Profile Menu
To add a new call profile to the list of existing call profiles for the
previously selected port, select A in the Port n PRI Call Profile
Configuration Menu. Select the appropriate key for each
parameter.
The minimal information required to create a call profile is:
• Reference ID
• Direction (incoming/outgoing/both)
• Number of Own Digits
• Own Call Number
• Extension Number of Digits
• Extension Call Number
NOTE: Acceptance of the call profile does not imply the completeness of the
information required to describe your configuration.
Command Description
A Add Call Profile—Displays the PRI Port 1 Add Call Profile Menu, Figure 3-14, Table 3-14.
M Modify Call Profile—Prompts for selection of a call profile to be edited,
Port n Enter Call Ref ID (0-0):
then displays the Modify Call Profile Menu.
Modify the Call Profile items by selecting the appropriate keys.
WARNING: After making changes, remember to select the option,
S) Send Call Profile
or the changes will not be set up.
S Set Call Action—Prompts for selection of a call profile to define the profile to be set up or
taken down.
Port n Enter Call Action Ref ID (0-MAX):
Port n -- Set Call Action:
1) Setup Call 2) Take Down Call 3) Exit
D Delete Call Profile—Prompts for selection of a call profile ID for the call profile to be deleted.
Port n -- Disable entry number (0-0):
CAUTION 1: The prompt says "disable", but the result is deletion of the entry from the
list of call profiles. If you change your mind about deleting a call profile, enter a non-
numeric value at the prompt or enter a carriage return.
CAUTION 2: No confirmation prompt will be displayed when the requested profile is deleted.
X Exit to the PRI Call Profile Configuration Menu, Figure 3-12, Table 3-12.