Control connections, 1 − introduction – Teac SS-R05 User Manual
Page 8
1 − Introduction
TASCAM SS-R1
The pinouts of the
CONTROL I/O
(
PARALLEL
) terminal
on the rear panel (see “Rear panel” on page 10) are:
Pin
Function
IN/OUT
1
GND
—
2
Play/Flash 1
In
3
Stop/Flash 2
In
4
Record/Flash 3
In
5
≤
(Next)/Flash 4
In
6
µ
(Previous)/Flash 5
In
7
Flash Load
In
8
Fader Start
In
9
Flash Tally
Out
10
Ready Tally
Out
11
Record Tally
Out
12
Stop Tally
Out
13
Play Tally
Out
14
Remote Select*
2
In
15
Ready/Flash 6
In
16
Call/Flash 7
In
17
Auto Cue/Flash 8
In
18
Auto Ready/Flash 9
In
19
Pitch/Flash 10
In
20
Flash Page*
3
In
21
EOM Tally
Out
22
CF Tally
Out
23
—
—
24
—
—
25
+5V*
1
—
In: External command reception active flow
(operates at 30 ms or longer of ground)
Out: transport status by open collector
Indication signal (maximum voltage 15 V, maximum current
50 mA)
*1 Maximum supplied current is 50 mA.
*2 Pin 14 (Remote Select)
When this pin is high, the input pins for which the above
table lists two commands separated by a “/” (pins 2–6
and 15–19) will perform the first-listed function, and can
be used as conventional parallel controllers.
When this pin is low, the above-listed input pins will
function as flash start keys.
*3 Pin 20 (Flash Page)
When pin 14 (Remote Select) is low, the assigned tracks
will be as follows according to the high/low state of pin
20.
#14
#20
Flash-start status
Low
High
1–10
Low
Low
11–20
Tall signals are open collector, with a maximum current
of 50 mA. Input signals are active when low (ground)
for ≥ 30 ms.
A fader start/stop control should be wired according to the
following schematic:
START
STOP
Pin 1
FADER START
Pin 8
GND
PARALLEL
Control connections