Teac SS-R05 - Manual (Page 10)

2 − Controls and connectors
10
TASCAM SS-R1
w CALL key When you press this key, the SS-R1 will
search for the call point (the point at which playback
was most recently started from the pause condition),
and will enter pause mode (see “Call function” on page
30).
When editing a name, this key inserts a space.
e STOP key When you press this key while playing
back or recording, playback or recording will stop.
Pressing this key while stopped or while selecting a
track will cancel the track selection.
Pressing this key while stopped in program mode will
clear all programs.
Pressing this key while editing will cancel the editing
operation.
r PLAY key While stopped or paused, press this key to
start playback.
While in the record-ready condition, press this key to
start recording.
The key will light during playback or recording.
t READY key While stopped or paused, press this key
to enter the pause condition.
While recording, press this key to enter record-ready
mode.
y RECORD (TRACK INC) key While stopped, press
this key to enter record-ready mode.
While recording, press this key to increment the track
number.
The key will light when in recording mode.
If you press this key when a CompactFlash card is not
inserted, the input monitor will be activated, and the
selected input signal will be output. The key will blink
while input monitor is active.
u KEYBOARD connector You can connect a PS/2
keyboard here.
Set the UTILITY menu KEYBOARD setting appro-
priately for the type of keyboard you’ve connected (see
“Specifying the keyboard type” on page 60).
i PITCH knob Turn this knob to adjust the pitch (play-
back speed).
You can press this knob to turn pitch control on/off.
By holding down this knob you can access pitch step
switch mode (see “Pitch control play” on page 26).
o PHONES knob, PHONES jack You can connect
stereo headphones to the PHONES jack.
Use the PHONES knob to adjust the headphone vol-
ume.
Rear panel
p ANALOG INPUTS L/R (BALANCED) jacks These
are analog input jacks (XLR balanced).
The nominal input level is +4 dBu.
Pin wiring: pin 1 = ground, pin 2 = hot, pin 3 = cold.
a ANALOG INPUTS L/R (UNBALANCED) jacks
These are analog input jacks (RCA pin jacks).
The nominal input level is -10 dBV.
s ANALOG OUTPUTS L/R (UNBALANCED) jacks
These are analog output jacks (RCA pin jacks).
The nominal output level is -10 dBV.
d ANALOG OUTPUTS L/R (BALANCED) plugs
These are analog output plugs (XLR balanced).
The nominal output level is +4 dBu.
Pin wiring: pin 1 = ground, pin 2 = hot, pin 3 = cold.
f DIGITAL IN/OUT (COAXIAL) jacks These are
digital input/output jacks compatible with IEC-60958
(S/PDIF).
g CONTROL I/O (RS-232C) connector This is a
D-sub 9-pin RS-232C connector for control I/O. You
can connect it to an external computer or other device
(see “Using the RS-232C connector” on page 63).
h CONTROL I/O (PARALLEL) connector This is a
D-sub 25-pin parallel connector for control I/O. You
can connect it to an external controller. For the pin
wiring, refer to “Control connection” on page 8.
j REMOTE IN connector Connect the RC-SS1 dedi-
cated remote here.
k AC IN connector Connect the included power cable
here.